Elevator control arm for 1/32" wire (2pcs)

This custom-designed 3D-printed part is to make a control arm for an elevator (or flap or aileron).  Its meant to be glued onto a 1/32 (0.8mm) elevator joiner wire with thin CA, then operated with a 1/32" pushrod (or pull-pull system) by a servo.  The wire is not included!  Hopefully the pictures are explanatory. This is made for use with SMALL models. Sold in a pack of 2 pcs.

Dimensions:  The arm is about 1 inch long and 1/16" thick with 4 pushrod holes on each side, and the center part is  1/2" tall. Suitable for 1/32" wire. The pushrod holes are for 1/32" wire.  Weight: 0.5gm each. White PETG plastic.

These pictures show a typical setup for an elevator joiner rod.  The control arm has two sides so it can be used with a single pushrod from either side (and you can cut off the other side) or you may use a pull-pull setup.  The wire and plastic tubing is not included!

 

This product was designed and manufactured by Rabid Models and Fun Scale Models, Copyright © 2025  Made in the USA.